Preizkusite novo različico: COBISS+
 Vzajemna baza podatkov: COBIB.SI - Vzajemna bibliografsko-kataložna baza podatkov (Štev. zapisov: 4.952.621)

Izbrani zapis trajna povezava

AvtorHorvat, Maša, 1983-
Vidmar, Tjaša, 1987-
Maček, Marijan
Urbas, Raša
Golob, Gorazd, 1955-
Čekada, Miha
Klanjšek Gunde, Marta
Naslov Flat-plate capacitors printed on paper / Maša Horvat ... [et al.]
Vrsta/vsebinatype of material članek - sestavni del
Jezikangleški
Leto2012
Fizični opisstr. 171-176
OpombeSoavtorji: Tjaša Vidmar, Marijan Maček, Raša Urbas, Gorazd Golob, Miha Čekada, Marta Klanjšek Gunde
Bibliografija: str. 176
Abstract
Predmetne oznake (nekontrolirane)tiskarstvo / tiskarska črnila / UV sušenje / printed electronics / conductive ink / dielectric ink / ultraviolet curing / capacitance
PovzetekMultilayered passive electronic elements were screen-printed on the conventional paper and on the paper developed for printed electronics. The solvent-based electrically conductive ink with silver particles was applied for conductive plates and the UV-curable dielectric ink for the interlayer. The conditions for good print and electrical quality were determined other than those recommended by the producer. When dielectric layer was single-printed, the capacitance of flat-plate capacitors and the occurrence of electric defects depend on UV curing energy applied for dielectric layer. The effect was explained by partial dissolving of the bottom conductor with the solvent from the wet top layer. The effect vanishes when the dielectric layer is cured with about three times the recommended DV curing dose. The entire phenomenon disappears completely when the dielectric layer was double printed wet-on-dry, with the recommended DV curing. Capacitors with 10-20% higher capacitance were obtained on smooth surface of paper dedicated for printed electronics.
COBISS.SI-ID5056538
Glej publikacijo TI=Journal of print and media technology research ISSN: Y507-1976 ; 2223-8905.- Vol. 1, no. 3 (2012), str. 171-176